TISSEL-100

Description
TISSEL 100 are compact pumping units composed by a centrifugal pump with an integrated speed regulator (inverter) complete with a pressure sensing device built-in.
Sturdy and very easy to use. They are the perfect solution to get a constant pressure in every tap of the system.
The inverter is a water cooled type, and has an IP 65 protection grade. It receives a single-phase alternate voltage  (230±10% V - 50/60 Hz) and supplies a three-phase alternate output voltage which supplies the motor of the pump with an IE3 performance class.
The wear of the water pump components is reduced due to the low speed of the motor during its duty life and it is progressively started and stopped.

ENERGY SAVINGS
A significant energy savings in terms of low flow rates. It is like running a lower power pump.

PROTECTIONS
- Dry running protection.
Stops the pump after a few seconds and tries to resume at intervals of time in order to check whether the water is present or not in the system.
- Running with a pressure inferior than the minimum pressure set.
Stops the pump after a few seconds (for example, when a pipe is broken).
- Currents – Voltages - Temperatures.
Limits the currents; complete with an alarm for out-of-limit voltages; protects from over-temperature and short-circuit between the output phases.

Caractéristiques

Typologie du liquide: Eau claire

Utilisations: domestique, bâtiment

Emplois: irrigation, exploitant d'eau, installation de surpression

typologie: pompes électriques avec inverseur

Famille: centrifuge

Champs des prestations:

  • Débit jusqu'à 160 l/min (9,6 m³/h)
  • Hauteur jusqu'à 62 m

Limites d'utilisation:

  • température du liquide jusqu'à +40 °C
  • Température ambiante jusqu'à +40 °C
  • Maximum liquid temperature:
   +40 °C TS1-4CP 100, TS1-5CR 100
   +55 °C TS1-2CP 25/130, TS1-2CP
  • Manometric suction lift up to 7 m
  • Max. working pressure:
   6 bar TS1-4CP 100, TS1-2CP 25/130
   7 bar TS1-5CR 100, TS1-5CR 100
  • Continuous service S1